30369-18-0619
Page 30
OPTIONAL BLOWER ACCESSORY INFORMATION
The appliance, when installed must be electrically connected
and grounded in accordance with local codes or, in the
absence of local codes, with the current CSA C22.1 Canadian
Electrical Code.
U.S. Installations, follow local codes and the National
Electrical Code, ANSI/NFPA No. 70.
Should this blower require servicing, the power supply
must be disconnected. For rewiring of any replacement
components, refer to Figures 43 and 44 and the parts list
included with the blower assembly instructions.
BLOWER ACCESSORY
Operation
The fireplace is equipped to receive an optional FBB8 blower
accessory that includes a fan control switch, plus a rheostat
(speed control).
If you choose to install the optional blower, you can expect it to
operate as follows:
From a cold start, the temperature activated fan control switch will
normally take 5-10 minutes to heat up and energize the blower.
Once the blower is energized, adjust the blower speed control as
desired, then replace the surround kit assembly.
When the fireplace is shut off, it may take 30-40 minutes for the
heated unit to dissipate (cool down) enough for the blower to shut
off automatically.
NOTICE
: The blower shut off times will vary on
blower speed and BTU input level setting control by adjustment of
the HI/LO knob located on the gas valve.
NOTE:
For installation of FBB8 blower accessory, refer to the
instructions included with the blower kit.
NOTE:
The fan control switch is secured with two 8-32 Hex nuts to the
bottom side of the firebox. Threaded studs are provided at the center
of the fireplace, approximately 5” behind the front of the fireplace.
Figure 43
Figure 44
FAN CONTROL
SWITCH
FBB8 BLOWER ASSEMBLY
VALVE
PIEZO IGNITOR
REMOTE/OFF/ON SWITCH
FAN SPEED CONTROL
JUNCTION BOX
