![background image](http://html1.mh-extra.com/html/empire-comfort-systems/archway-2300-insert/archway-2300-insert_installation-and-operation-manual_2404163020.webp)
Page 20
Installation and Operation Manual - Gateway 2300
ENGLISH
5.2.3 Two Parallel Logs Method
Two spit logs are placed in the firebox with a few sheets of twisted newspapers in between the
logs. Fine kindling is added across the two logs and some larger kindling across those, log cabin
style. Newspaper is lit.
5.2.4 Using Fire Starters
Commercial fire starters can be used instead of a newspaper. Some of these starters are made
of sawdust and wax and others are made of specialized flammable solid chemicals. Always
follow the package directions when using.
Gel starters can also be used, but only to light a fire, in a cold combustion chamber without hot
embers inside.
5.3 Combustion Cycles
Wood heating with a space heater is very different than other forms of heating. There will be
temperature variations in different parts of the house and there will be temperature variations
throughout day and night. This is normal, and for experienced wood burners these are advantages
of zone heating wood burning.
Wood heaters don’t have a steady heat output. It is normal for the temperature to rise after
a new load of wood is ignited and for its temperature to gradually decrease throughout the
burning cycle. This increasing and decreasing temperature can be matched with the household
routines. For example, the temperature in the area can be cooler when the household is active,
and it can be warmer when it is inactive.
Wood burns best in cycles. A cycle starts when a new load of wood is ignited by hot coals and
ends when that load has been consumed down to a bed of charcoal about the same size as it
was when the wood was loaded.
Trying to produce a steady heat output by placing a single log on the fire at regular intervals
is not recommended. Always place at least three, and preferably more pieces on the fire at a
time so that the heat radiated from one piece helps to ignite the pieces next to it. Each load of
wood should provide several hours of heating. The size of each load may vary depending on the
amount of heat required.
Burning in cycles means the loading door does not need to be opened while the wood is flaming.
This is an advantage since it is preventing smoke leaking from the heater when the door is
opened as a full fire is burning. This is especially true if the chimney is on the outside wall of the
house.
5.4 Rekindling a Fire
When the temperature of the room is lower and all that remains is embers, it is time to reload.
Most of the remaining embers will be at the back of the firebox. Remove excess ash from the
front of the firebox and bring the embers forward before reloading. Place a new load of wood on,
and at the back of the embers. Open the air control completely and close the door.
If the door must be opened while the fire is flaming, fully open air control for a few
minutes then open the door slowly.
Содержание ARCHWAY 2300 INSERT
Страница 2: ......
Страница 6: ...Page 6 Installation and Operation Manual Gateway 2300 ENGLISH CERTIFICATION PLATE ...
Страница 62: ...Page 62 Installation and Operation Manual Gateway 2300 ENGLISH NOTES ...
Страница 63: ......