Page 8
XPA Gen3
XPA Gen3 Chassis Rear Panel (XPA Gen3 five shown)
1. Status LEDs Switch
Disables the front panel status LEDs when set to Off.
2. Trigger Input and Trigger Output
The XPA Gen3 is switched On (from Standby) when a trigger signal is presented at the Trigger
Input; the XPA Gen3 returns to Standby when the trigger signal is removed. When the XPA Gen3 is
on, a 12 VDC signal is sent from the Trigger Output to control other devices.
3. Amplifier Modules (see next section for details)
The XPA Gen3 chassis can be configured with anywhere from two to seven amplifier modules.
All installed amplifier modules are powered by the XPA Gen3’s power supply, and controlled and
monitored by the XPA Gen3’s microprocessor-controlled front panel and Status LEDs.
Note: The XPA Gen3 can be upgraded after purchase by adding additional amplifier modules.
The front panel controls and indicators will automatically configure themselves to work with
the number of amplifier modules installed. Only the Status LEDs associated with the modules
currently installed will be illuminated.
Note: Amplifier modules should only be serviced, removed, rearranged, or installed by Emotiva
or your local Emotiva authorized service center.
1
3
2
4
6
5
7
TRIGGER
INPUT
TRIGGER
OUTPUT
ON
OFF
STATUS LEDS
CIRCUIT BREAKER
POWER
20A 125/250V~
INPUT SELECT
+
_
INPUT SELECT
+
_
INPUT SELECT
+
_
INPUT SELECT
+
_
INPUT SELECT
+
_
