ERD-1 Wall Mounting
Caution:
Do not over tighten the mounting screws on the back of the ERD-1 speaker. They are not designed
to sit flush and over tightening can strip the insert into which the screw is attached. Remove the grilles
before installing the speakers, and mount them only when speakers are in a fixed, stable position.
20
lates!
) When positioning the plate for
lace
) Use a stud-finder to determine the
are.
) When the bracket is mounted,
et.
e
f
) Set the switches (see page 14) for
ound or
) Carefully lift the speaker to the
es, let
Connections
1) The ERD-1 is designed to be wall
mounted with the included mounting
plate. Please use wall anchor
hardware capable of supporting up to
20 pounds or mount the plates
directly against a wall stud with the
appropriate hardware. Do not use
drywall screws to mount these p
2
hardware location/installation, the
Emotiva logo should be facing
outwards, towards you, as you p
it on the wall.
3
location of a stud and that will
determine your choice of hardw
Carefully drill the wall and install the
appropriate hardware to mount the
bracket.
4
install 2 foam strips on each brack
Peel the cover on the adhesive side
of the strips and stick them to the
ridges that run vertically between th
top and bottom keyholes on each
side of the mounting plate.
(Foam
strips may be attached at factory. I
so, go directly to step 5).
5
the mounting position and
configuration (5.1, 7.1, Surr
Side, etc.).
6
plate and connect the wiring to the
terminals. Then, lining up the
mounting screws to the keyhol
the speaker gently slide down into
place on the bracket.
Connection Tips for Superior
