5
2. Use the same method – pressing HOUR or MINUTE button to set hours and minutes. The procedure
can be speeded up if during the setting the button is held.
3. The day and time setting procedure is finished and the values are set when both CLOCK and HOUR
or MINUTE buttons are released.
In order to erase the incorrect data, repeat step 1 to 3.
If, even after then the display is not lit, press MASTER CLEAR button.
Programme setting
1. Press TIMER button and release. The first time programme setting is on 1_ON.
2. Press WEEK button to select day or day period in the week. Set time 1_ON by HOUR and MINUTE
button.
3. Press TIMER button again – thus the first time programme setting is finished 1_OFF, by the same
method as 1_ON.
4. The 8 time programmes can be adjusted by repeated TIMER button pressing.
E.g.: TIMER ON (socket on) at 18:15 and TIMER OFF (socket off) at 22:15 every day.
a) press TIMER and the display shows ....“1_ON“
b) press WEEK (day)........................................“MO,TU,WE,TH,FR,SA,SU“
c) ..........HOUR ..................................................18:00 or 6:00 PM
d) ..........MINUTE (minutes ...........................18:15 or 6:15 PM
e) ..........TIMER ..................................................“1_OFF“
f) repeat steps b to d to adjust ..................22:15 or 10:15 PM
Pressing CLOCK button allows the return from setting mode to the standard mode at any time.
ADVICE: After the setting make sure that the adjustment is not dual, especially with the period adjustment.
Adjustment of ON/AUTO/OFF
1. Press ON/AUTO/OFF and select on of the three modes:
– MANUAL ON – the socket is permanently on.
– MANUAL OFF – the socket is permanently off.
– AUTO – the socket operates according to the set programmes.
2. After being switched from MANUAL to AUTO, TS-ED1 will contain the MANUAL setting (either on or
off) until the new programme is adjusted.
12/24 hour mode
Press CLOCK and TIMER buttons at the same time and select 12 or 24 hour mode.
Summer time
1. Press CLOCK and ON/AUTO/OFF buttons at the same time, the display shows „SUMMER“.
2. The time will show one hour ahead.
3. When the buttons are pressed again, the time will return back to its original state.
Reset button
When RES/RCL button is pressed, the value, which has been set, is erased. This button does not erase
the total memory.
RANDOM button
It operates in AUTO mode, the display shows „RANDOM“. If activated, the appliance is switched on in
random way in approx. 0–32 minute steps during the time period between 6 p.m. until 6 a.m.
Warning
• If the display fails to operate, plug TS-ED1 into the socket with 230 V AC and let it recharge.
• Within approximately 2 hours the display is on and TS-ED1 is fully prepared for operation.
• TS-ED1 is fully recharged after 12 hours of recharging.
• The device must not be used in plugs whose protection exceeds 16 A. The possibility of switching
induction load is limited by max. 2 A. The appliance plug must be always checked for complete
insertion in the terminal. If TS-ED1 must be cleaned, switch it off and clean it with a dry cloth.
• Do not leave the connected electrical appliances without attention.
