Emos P4519, Руководство пользователя

Страница: 3 / 24

3
Changing the Accumulator:
The accumulator should only be changed by a skilled user, ideally with qualifications in electrical engineering.
1. When changing the accumulator, turn the lamp switch to the off position.
2. Carefully remove the screws from the rear cover of the lamp and take the lamp apart.
3. Remove the accumulator pack and replace with a new one with same dimensions and electrical parameters. The new
accumulator must be purchased only from the manufacturer. Never use non-original components. Make sure to observe
the correct polarity when changing the accumulator.
4. Reassemble the lamp by reversing the procedure for disassembly.
WARNING
• When new, the lamp must first be charged before use.
•
The lamp can be recharged using a car adapter only when the vehicle is stationary and the engine is turned off.
Do not under any circumstances charge the lamp when the car engine is running or the car is in motion.
•
The lamp‘s accumulator must be kept charged to prevent the voltage from dropping below the threshold level.
Therefore, it is recommended to recharge the lamp at least once every 3 months even when it is not being used.
• If the lamp does not shine or the light is weak, immediately recharge.
• If the accumulator is damaged or destroyed due to non-observance of the above rules, complaints filed within the warranty
period regarding the lamp (accumulator) will not be recognized.
• Use the network adapter type TEKA006-0501000EUU only for recharging the lamp; do not recharge batteries not designed
for the purpose.
• The network adapter and car adapter must be used in dry indoor areas.
• When replacing the accumulator, make sure to observe the correct polarity.
• Do not throw the accumulator into a fire and do not disassemble or short-circuit it.
• After depletion, the accumulator becomes hazardous waste. After depletion, do not dispose of the accumulator in municipal
waste. Turn the accumulator in at take-back sites such as the shop where the lamp was purchased.
• After the end of its service life, the entire lamp shall be disposed of ecologically.
• If water enters the interior of the lamp, remove the accumulator and dry the interior of the lamp thoroughly. Do not under
any circumstances use the lamp.
• The lamp is not intended for use by persons whose physical, sensory or mental disability or lack of experience and expertise
prevents its safe use, unless they are supervised or instructed in the use of the appliance by a person responsible for their
safety. Children should not be allowed to play with the lamp.
Do not dispose of electrical appliances as unsorted municipal waste; use sorted waste collection points. Contact local
authorities for up-to-date information about collection points. If electrical appliances are deposited in waste landfills,
hazardous substances can leak into the groundwater, get into the food chain and harm your health and comfort
Delivery List:
Lamp
Network power adapter type TEKA006-0501000EUU
Car adapter 12/24 V=
Recharge cable
Manual
CZ
Nabíjecí LED svítilna – E4007L
Specifikace
Nabíjecí svítilna je odolná proti nešetrnému zacházení (prach, špína), proto je vhodná pro techniky, kutily, chataře a také
do auta. Svítilna má magnet a hák na zavěšení. Reflektor svítilny je možné natáčet horizontálně o 45° na obě strany i vertikálně
o 180°. Svítilna má stojánek pro použití jako např. stolní lampička. Doba nepřetržitého svícení při plně nabitém akumulátoru
je přibližně 2,5 hodiny. Svítilnu lze nabíjet, případně dobíjet ze sítě 100–240 V~, 50/60 Hz, nebo z automobilové zásuvky
12/24 V=. Svítilnou lze svítit při nabíjení akumulátoru.