Emos H2015, Руководство пользователя

Страница: 5 / 44

5
Conductor core diameter [mm] 0.5 0.65 0.8 1
Distance [m] 20 50 70 115
In the basic implementation, a coaxial cable is not required. Such a cable is only recommended for distances over 100 m.
For long ground cabling, you can use a telecommunication cable of category TCEPKPFLE.
Operation of the Device
- To ring the bell and call up the image on the videophone, press the button
on the door unit.
- To accept a call, press this button on the videophone.
- To immediately call up the image from the door unit, press this button.
- To send a signal to the electrical lock and gate, press these buttons.
- You can set gamma and image saturation as well as voice volume, ringtone volume and ringtone in the menu.
Device Maintenance
The device is low-maintenance. It is recommended, based on the state of the device, to occasionally wipe the device down
with a moistened cloth.
Warning!
Before cleaning, the device must be disconnected from power supply!
Safety Warning
- Do not place the videophone in the proximity of TV receivers or into environments with high temperature or humidity.
- Do not touch the TFT LCD display or the monitor by hand and do not disassemble the door unit.
- If sunlight shines directly into the lens of the door unit, the image on the videomonitor may become illegible.
- Do not subject the device to vibrations or falls.
FAQ
The device does not work
Check the cables and the connection of the power adapter to the network. If you extended the cable from the power adapter,
check that the polarity is correct. Measure the adapter with a multimeter. The output voltage on the connector should be 12
V DC (+/- 1 V).
The image/sound is not clear, the device does not ring
Remove the monitor or the door panel and connect it using a short cable to eliminate the possibility of a disrupted conductor
in the house.
Then check the image and sound settings (brightness, contrast, colour, volume).
The lens steams up
This occurs mainly during cold weather, where condensation occurs due to the temperature difference between the wall and
the door unit itself. If water condenses on the lens, we recommend thoroughly drying the unit and modifying the installation.
Spontaneous ringing
Spontaneous ringing is caused by moisture entering the camera. Water short-circuits the contacts on the lock switch and the
device will start ringing on its own. We recommend dismounting the door unit, drying it thoroughly and spraying it with water
repellent for electronics.