4
• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination, television sets and com-
puters located near the DCF receiver.
Setting time manually, time format
1. Press and hold the TIME button.
2. Use the UP/DOWN buttons to set the following parameters: year – month – day – hour – minutes – seconds – calendar
language (GB, FR, DE, ES, IT).
Press TIME to move between the items.
Holding the UP/DOWN buttons adjusts values faster.
If no button is pressed within 30 seconds, the unit will revert to the basic display.
After setting is complete, press the 12/24 button repeatedly to set display in 12/24 hour format.
Indoor and outdoor temperature, temperature unit
Indoor temperature is displayed below the IN icon.
The outdoor temperature is displayed below the OUT icon.
Repeatedly press °C/°F to select temperature unit of °C or °F.
Display of the maximum and minimum temperature reading
Maximum and minimum readings of the measured indoor and outdoor temperatures are automatically recorded in the memory
of the weather station.
Press repeatedly MAX/MIN to display the readings measured.
To clear the memory, press and hold MAX/MIN.
Cyclic display of the connected sensor readings
If you have connected several sensors, press and hold the CHANNEL button.
Weather station will cycle (interval of 4 seconds) the readings from all connected sensors.
Press CHANNEL to cancel the cycling mode.
Press CHANNEL repeatedly to display sequentially data from all connected sensors.
Temperature trend
The arrow shows the trend of temperature measurement values on the specific sensor or station.
Indicated on the display
Temperature trend
rising
constant
falling
Setting an Alarm
2 alarms can be set on the weather station.
Use the TIME button to select alarm no. 1 (AL1) or no. 2 (AL2). The choice will be displayed at the top left of the display.
Press and hold ALARM and UP/DOWN buttons to set the desired alarm time.
Press the ALARM button to move between the readings.
Activate/deactivate the alarm by repeated brief pressing of the ALARM button.
The
,
icons will appear.
Snooze function
Press the SNOOZE button to delay ringing of the alarm by about 5 minutes.
Press the button when the alarm starts ringing. The alarm icon will be flashing.
To cancel the SNOOZE mode, press the ALARM button – the bell icon stops flashing and stays displayed.
The alarm will be re-activated the next day.
The alarm will be active for 2 minutes, if no button is pressed.
Temperature alarm of the outdoor temperature
On the weather station, you can set the temperature alarm for the outdoor temperature.
Setting of the temperature alarm can only be activated with the alarm activated as well.
Repeatedly press the TIME button, AL1/AL2 will appear.
Then press the ALARM button twice to display the bell and LO icon.
The LO Icon stands for the activation of temperature alarm of the outdoor temperature.
If the outdoor temperature drops below -3 °C (applies to any connected sensor), an audio signal sounds for 2 minutes.
Press the SNOOZE button to postpone the alarm by 5 minutes.
To end the audible signal, press ALARM.
The audible signal will sound 30 minutes before the set alarm time (time limit cannot be changed).
Example:
Temperature alarm time is set for 13:00 hours.
If the outdoor temperature is below -3 °C, the audible signal of temperature alarm sounds at 12:30.
Weather Forecast
The station forecasts weather on the basis of changes in atmospheric pressure for the next 12–24 hours for an area within the
range of 15–20 km. Accuracy of weather forecast is 70–75 %. As the weather forecast may not be 100% accurate neither the
manufacturer nor the seller can be held responsible for any loss caused by an incorrect forecast. When you first set or reset the
