015
Operation
Operation
MTRX2 Power Modes and Precautions:
Off:
AC power is disconnected either using the Main Power Breaker Switch in the
back of the MTRX2 or by disconnecting/removing the main power cable
from the power inlet. Please see diagram on the right.
Standby:
Power cable connected and Main Power Breaker Switch turned to the ON
position. Safety, control and operational systems are enabled. MTRX2 indicator
lights will glow RED. In Standby mode the MTRX2 consumes minimal power.
On:
Once in Standby mode press the front panel Standby button to fully power the
MTRX2 amplifier. The MTRX2 amplifier will take between 5-10 seconds to go
through a complete systems and safety check before enabling full power. Once
at full power the MTRX2 indicator lights will glow BLUE.
Ind. Off:
MTRX2 will be ON but indicators will be off. Press and hold the front panel
button for 2 seconds while in Standby mode. The MTRX2 will fully turn ON,
indicators will glow BLUE for a few seconds before dimming and turning off.
To re-enable indicators, press the front panel button for Standby mode then
back ON again.
Recommended Turn ON an Turn OFF Sequence
Turn ON Sequence:
1. Check that Main Power Breaker Switch is OFF (down position)
2. Connect speakers/speaker cables to MTRX2 amplifier
3. Connect power from wall plug to power inlet of the MTRX2 amplifier
4. Plug in audio input from source components
Main Power
Breaker Switch
Power
Inlet
Voltage
Indicator Label
MTRX2 AMPLIFIER OWNER’S MANUAL
© 2017 EMM Labs Inc., All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.
