EMKO Proop Series, Руководство пользователя

Страница: 8 / 24

!
Before starting the installation of the device,read the following
warnings carefully.
SETUP
Before carrying out the installation of the device, it must be checked against
damage that may occur during transportation. Installation and commissioning must
be done by mechanical and electrical technicians. This responsibility belongs to the
buyer.
Never use the device in environments where flammable and explosive gases are
present.
Avoid exposing the device to direct sunlight or any type of heat source.
Transformer, motor etc. near the device. such as magnetic objects or interference
generating devices (such as welding machines, etc.).
In order to reduce the effect of electrical noise on the device, the low voltage line
(especially the sensor input cable) cables should be separated from the high
current and voltage line.
Necessary precautions must be taken for all parts that may create a hazard on the
mechanical parts of the device. These measures are necessary for the safety of
the personnel who will assemble.
The device must be mounted on the system with its own fixing parts. Do not
assemble the device with unsuitable fixing parts. Mount the device with the fixing
parts to ensure that the device will not fall.
If possible, use shielded cable. The screen should be grounded to one side only.
In order to prevent electrical shocks and similar accidents, the device and the
system where the installation is made should not be energized before all
connections of the device are completed.
Digital outputs and supply connections are designed by isolating each other.
Before commissioning the device, the parameters must be adjusted according to
the desired use.
Incomplete or incorrect configuration can cause dangerous gaps.
07