TB-6594
Page 7 of 12
© 2018 DESCO INDUSTRIES, INC.
Employee Owned
EMIT
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 664-9980 • Website:
DescoEMIT.com
10mm Wrist Cord Adapter
A plunger and spring assembly is included with every
SmartLog Pro®. Use this assembly to retrofit the
single-wire jack on the SmartLog Pro® to test wrist
cords with a 10mm termination instead of a banana
plug. NOTE: This assembly cannot be removed once
installed.
1. Insert the plunger assembly into the single-wire
jack on the face of the SmartLog Pro®. Be sure to
clear the clip at the base of the plunger’s shaft when
inserting into the jack.
6. Connect the SmartLog Pro® to the bracket. Use the
included thumbscrew to secure the SmartLog as
shown below.
Figure 5. Securing the SmartLog Pro® to the mounting
bracket
Figure 6. Use the EMIT 50415 SmartLog Stand as a
mounting alternative
2. The plunger will slightly protrude out of the
single-wire jack when installed. Test its installation
by pushing down on the plunger. It should dip and
then spring back up when released.
Figure 8. Completed installation of the plunger and
spring assembly
Figure 7. Inserting the plunger and spring assembly into
the single-wire jack
