39
|
ENGLISH
8.7 Test the motion detector
1. After you fully installed the motion detector and the self-test is completed you can
test the motion detector by walking within the range of the motion detector from
one side to the other side.
2. The LED indicator of the motion detector will flash if motion is detected.
3. Adjust the motion sensor to get the best results. And repeat the test.
Notice: The motion detector has an energy saving mode. If the sensor is active and
the motion detector registers 2 motion within the registered 3 minutes the sensor will
go in sleep mode; not active.
After 3 minutes the sensor will check if there is still motion detected if no motion is
detected the motion detector will be active again. To test the motion detector please
make sure the motion detector has not registered any motion during 3 minutes before
you test the motion detector!
9.0 Install the Window/Door sensor
9.1 Register the window/door sensor
1. Make sure the sensor and the magnet are located next to each other.
2. Push the
button on the back of the alarm system.
3. Now separate the magnet from the sensor. The sensor will be triggered. If you
hear a beep the sensor is registered to the system. If you hear 2 beeps this
indicates this sensor is already registered.
