36
|
ENGLISH
8.5.1 Infrared sensors
The infrared sensors detect the motion. These sensors need to be clean at all time.
Do not touch the sensors!
8.5.2 Anti sabotage button
If the motion detector is opened this switch will detect it and trigger the alarm.
8.5.3 LED On/Off
By switching this jumper setting you can set if the LED in front of the motion detector
will be switched “On or Off”. By default this setting is turned ON (LED ON).
8.5.4 Group settings (jumpers)
Every sensor can be configured to be added to a dedicated group by setting the
jumper settings; home-group, normal group, single or 24-hours group.
Bellow you will see an overview of the meaning and how to configure the jumper
settings for that type of zone.
Remark: Determine before pairing with the alarm system in which group the sensor
will be operational. Once the sensor is successfully paired with the system. The group
cannot be changed after pairing!
Remark: If the group of a sensor needs to be changed, all sensors need to be paired
with the alarm system once more. It is not possible to remove one single sensor from
a group! (See chapter “
Removing the registered Accessories
”)
Remark: It’s recommended to install detectors that need to be operational 24-hours,
for example smoke detectors, in the 24-hours-group.
Home-group
Normal-group
24-hours-group
Single-group
