EMFIT Manual-SafeBed-SafeSeat-t46-v1-1-5-v3.0-ENG
www.emfit.com
12
13. TROUBLESHOOTING
Always check first that the installation is correct and test the device properly after every adjustment.
Notification is not getting forward via
other system the device is connected to:
• check that the connection cable is connected
correctly and is in good condition. often both
ends of the wire use same connector but wiring
order is not the same. Make sure it is connected
the right way!
Notification sound does not operate:
• check the volume level.
False notifications without reason:
• check the condition, positioning and connection
of the bed sensor.
• check the sensitivity according to “4. setting the
sensitivity” on page 6. It may be that sensitivity
is not set properly and device cannot always
notice micro-movements.
The device does not trigger absence i.e.
no movements notification and the green
light is blinking even if there is no one on
the bed
• check for possible external disturbances on the
bed sensor and its cable. Remove any external
disturbances causing vibrations.
• check the sensor and its cable. A broken sensor
or cable may cause disturbances to the signal so
that the green light blinks all the time. usually
this is detected by the device itself and red light
starts blinking. Also, sensor cable should be
away from any main outlet cables and should
not be hooked to the Ac adapter cable.
• If the cable and the sensor seem to be in order,
try reducing the sensitivity as some external
vibrations may cause this. see “4. setting the
sensitivity” on page 6.
The device does not trigger absence i.e.
no movement notification and the green
light is off when there is no one on the
bed:
• Is the green light blinking when there is someone
in bed? If not, check the sensor and its cable.
• check that the device is switched oN. It is oN if
the blue led light is blinking slowly. If it is not
blinking, press the sW1 switch for 3 seconds.
• check the sensitivity setting of the device when
a person remains still on the bed. Green light
should be blinking and system should activate
after person has been in bed for 40 seconds.
If necessary increase the sensitivity (see “4.
setting the sensitivity” on page 6).
Please never hesitate to contact the manufacturer if you need help or have feedback! All feedback is
highly appreciated!
14. CLEANING
the bed sensor can be cleaned with water and, when necessary, neutral general-purpose or mild antiseptic
detergents. Always dry the sensor after cleaning. use a moist cloth for cleaning the control unit.
the control unit must not get wet! do not clean the Ac adapter or the control unit when it is
connected to the mains outlet. Always dry it well after cleaning.
