COMPONENTS IN THIS PACKAGE
The wall outlet for your dispenser must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates your disposer, unless using an InSinkErator SinkTop Switch
™
.
PREPARATION
START HERE
Identify locations for the dispenser
faucet, tank and filter (if applicable).
Check to make sure counter is 2"
thick or less.
Make sure there is a grounded
electrical outlet under the sink.
Turn off water supply.
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
Using adjustable wrench, remove
nut connecting sprayer washer
flange in sprayer hole.
Plug hose opening with either a 1/8"
plug or a 1/4" cap
(not supplied).
1
a
b
If you have to drill through sink or
countertop, you may need to rent or
purchase the appropriate tools.
Consult a professional before drilling into
a surface other than stainless steel.
c
What if you don’t have a sprayer hole
or don’t want to use it?
Many homeowners replace the
soap dispenser in their sink with an
instant hot water dispenser.
If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the dispenser with
a hole saw for stainless steel, or you
can use a hole punch.
2"
2"
1-1⁄4” – 1-1⁄2”
Required minimum from
center of hole to wall
Maximum counter thickness is
Required Hole Size
H-SH10-SS
Semi-Circular
Mounting Plate
Rubber Washer
Plastic Spacer
3/4" Screws (2)
Tank
Long Nut
5
4
Property Damage:
Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
2
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
Feed tubes down the hole in
the sink or countertop until the
base is at rest on the sink or
countertop surface.
From under the sink, place the
rubber washer, plastic spacer and
semi-circular mounting plate onto
the threaded stud.
Place long nut onto the threaded
stud. Make sure faucet head is
at the desired angle. Tighten the
long nut until snug, while ensuring
the semi-circular mounting plate
extends beyond the sink hole.
Do not over tighten long nut. May cause
damage to faucet.
For sinks thicker than 1" the plastic spacer
is not required
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
INSTALLING THE FAUCET
b
a
c
NOTICE
