Emerson Rosemount 3051HT, Быстрый старт

Страница: 17 / 32

To configure SPM, refer to the Rosemount 3051 F
OUNDATION
Fieldbus
Reference Manual .
Procedure
1. Select AI Block Unit Setup .
2. Place the AI Block in Out of Service mode.
3. Select the signal conditioning L_TYPE from the menu.
• Select Direct for pressure measurements using the device default
units.
• Select Indirect for other pressure or level units.
4. Set the XD_SCALE to the 0% and 100% scale points (the transmitter
range).
a) Select the XD_SCALE_UNITS from the menu.
b) Enter the XD_SCALE 0% point.
This may be elevated or suppressed for level applications.
c) Enter the XD_SCALE 100% point.
This may be elevated or suppressed for level applications.
5. If the L_TYPE selected is Direct, the AI block may be placed in AUTO
mode to return the device to service.
6. If the L_TYPE selected is Indirect or Indirect Square Root, set
OUT_SCALE to change engineering units.
a) Select OUT_SCALE UNITS from the menu.
b) Set the OUT_SCALE low value.
This may be elevated or suppressed for level applications.
c) Set the OUT_SCALE high value.
This may be elevated or suppressed for level applications.
d) If the L_TYPE selected is Indirect, the AI Block may be placed
in AUTO mode to return the device to service.
7. To change damping, select Change Damping .
8. Enter the desired damping value in seconds.
The permitted range of values is 0.4 to 60 seconds.
9. To configure the LCD display (if installed).
10. Select
Local Display Setup
.
11. Check the box next to each parameter to be displayed to a maximum
of four parameters.
June 2020 Quick Start Guide
Quick Start Guide 17