22 – English – rM200
Bearings
There are two bearings in the rM200 sys-
tem. The bearings allow the drum to spin
smoothly when pushing the cable and pro-
vide resistance when returning the push
cable to the drum.
One bearing attaches to the rM200 case
and is located inside the front case.
rM200
case
bearing
The second bearing attaches to the drum
and is located on the drum’s underside.
Each rM200 model has a different bearing.
The bearings can fall out. Do not substitute
the bearings.
Replacing the Bearing
The bearing is on the underside of the drum.
A different bearing comes with each D2 se-
ries drum. The bearing can become dirty
and worn. To clean, rinse in warm water and
a mild detergent.
To replace the bearing, follow these steps:
1. Open the rM200 case.
2. Lift the drum out of the rM200 case
and turn over, with the counter keypad
faced down.
3. Replace bearing.
4. Return the drum to the rM200 case
and make sure the bearing faces
down and the counter keypad faces
up.
5. Spin the drum to make sure the drum
spins freely on the bearing.
6. Lock all six (6) of the rM200 case
latches.
NOTICE
Do not use the rM200 with-
out the bearing installed. If
the bearing is missing, the
push cable can damage or
break.
