Emerson Metro MPS-4009, Дополнение к руководству по эксплуатации

Страница: 35 / 50

MPS-4009 Multi-Chemistry Power Supply Operations Manual Supplement, Doc. No. L01-497
35
InterMetro Industries Corporation
Removing the MPS-4009 Power Supply
Caution:
For safety, only qualified service personnel should perform the following procedure
to remove the MPS-4009 Power Supply from the Metro Mobile Computing
Workstations.
To remove the MPS-4009 Power Supply from the workstation base for replacement,
perform the following steps:
Notice : Save all handle brackets, screws and other hardware that are removed by this
procedure for the replacement power supply to be mounted on the workstation.
If replacement hardware is needed, please contact InterMetro Customer
Service.
1. Disconnect all cables: DC Power connector, RJ45 cable from the Gauge port, USB from
the USB-B port and AC cable. Remove the AC cable clamp from the ground stud on the
back of the power supply.
2. Disconnect the batteries when shipping the power supply. See “Disconnecting the
Power Supply Batteries for Shipment” below.
3. Remove the two 8-32 pan head screws from the workstation power supply mounts on
each side.
4. Facing the back of the workstation, lift the power supply up to free the tabs from the slots
on the mounts on the bottom of the workstation base. Slide the handle brackets down
the ramp of the mounts and lift out the power supply.
5. Remove the three 8-32 pan head screws from each of the two handle brackets on each
side of the power supply.
Notice : The handle bracket hardware must be removed and the batteries must be
disconnected before returning the power supply to InterMetro Industries
Corporation.
Software Installation
The Metro BatteryPro software application installation file contains all drivers and applications
for Metro BatteryPro operation.
Notice: Typically, the Metro BatteryPro Mobile Computing Workstation Power Supply
Management software and drivers are installed at the factory and no additional
installation is required.
Notice: The software package should already be installed on the workstation computer before
plugging in the USB cable.