Emerson Dixell XR35CX - 110VAC, Инструкция по установке и эксплуатации

Страница: 19 / 40

The ON/OFF Function Parameters • 13
Hd1 First weekly holiday (Sun to not used ) Sets the first day of the week which follows the holiday
times.
NOTE: Hd1 can be set also as not used value.
Hd2 Second weekly holiday (Sun to not used ) Sets the second day of the week which follows the holi-
day times.
NOTE: Hd2 can be set also as not used value.
TO SET ENERGY SAVING TIMES (ONLY FOR MODELS WITH RTC)
iLE Energy Saving cycle start during workdays (0 to 23 hr 50 min)
During the Energy Saving cycle, the setpoint is increased
by the value in HES so that the operation setpoint is SEt
+ HES .
dLE Energy Saving cycle length during workdays (0 to 24 hr 00 min)
Sets the duration of the Energy Saving cycle on work-
days.
iSE Energy Saving cycle start on holidays. (0 to 23
hr 50 min)
dSE Energy Saving cycle length on holidays (0 to
24 hr 00 min)
TO SET DEFROST TIMES (ONLY FOR MODELS WITH RTC)
Ld1 to
Ld6
Workday defrost start (0 to 23 hr 50 min) These parameters set the beginning of the 6 programma-
ble defrost cycles during workdays. ( e.g., When Ld2 =
12.4 the second defrost starts at 12:40 during workdays .)
Sd1 to
Sd6
Holiday defrost start (0 to 23 hr 50 min) These parameters set the beginning of the 6 programma-
ble defrost cycles on holidays. ( e.g., When Sd2 = 3.4 the
second defrost starts at 3:40 on holidays .)
NOTE: To disable a defrost cycle, set it to not used. (e.g., If Ld6 = not used , the sixth defrost cycle is disabled.)
OTHER PARAMETERS
Adr Serial address (1 to 244) Identifies the controller address when connected to a
MODBUS compatible monitoring system.
pbC Type of probe Allows to set the kind of probe used by the controller:
Pt1 = Pt1000 probe
ntc = NTC probe
CtC = Standard CPC temp sensor
Set this pbC parameter to CtC to support standard CPC
temp sensors - factory default.
onF ON/OFF key enabling not used = disabled
oFF = enabled
ES = not set it
dP1 Thermostat probe display
dP2 Evaporator probe display
dP3 Third probe display (optional)
dP4 Fourth probe display
rSE Real setpoint Shows the setpoint used during the energy saving cycle
or during the continuous cycle.
rEL Software release For internal use only.
Ptb Parameter table code Read only
Code Parameter Function
Table 7-1 - List of Parameters