2.
Place the glass onto the light kit assembly aligning
the three flat areas on the top flange of the glass
with the three pins on the inside of the assembly
(Figure 17). Then turn the glass clockwise until it
stops turning.
3.
Your ceiling fan is now installed and wire to be
controlled by your remove control system.
9
LIGHT KIT
ASSEMBLY
75-WATT (max.)
MINI-CANDELABRA
(E11) BASE BULB
Figure 16
GLASS
PIN (3)
TOP
FLANGE
Figure 17
1.
Screw the 75-watt (maximum) mini-candelabra
(E11) base bulb (supplied) into the light kit socket
(Figure 16). Do not touch the glass bulb; use the
porcelain base to screw in the bulb, or wear
gloves.
CAUTION: To avoid risk of burns or other injury,
assure power is off before attempting to install or
replace the 75-watt (max.) mini-candelabra (E11)
base bulb.
CAUTION: To not touch 75-watt (max.) mini-
candelabra (E11) base bulb with bare hands.
Fingerprints may result in shorter bulb life.
Remove fingerprints with alcohol.
Light Kit Installation
1.
Place the switch cover onto the light kit assembly
aligning the three flat areas on the top flange of the
switch cover with the three pins on the inside of
the assembly (Figure 18). Then turn the switch
cover clockwise until it stops turning.
2.
Your ceiling fan is now installed and wire to be
controlled by your remove control system.
PIN (3)
SWITCH
COVER
TOP
FLANGE
Figure 18
If no light kit is desired, continue with switch
cover installation.
Switch Cover Installation
U.L. Model No.: CF3000
