Emerson Branson 2000 Series, Инструкция по эксплуатации

Страница: 114 / 135

100-214-251 REV. 05 105
6.5.2 Clearing Weld Cycle Alarms
Alarms occur when:
• the welder overloads;
• trigger is lost;
• hardware fails; or
• monitored parameters are not within limits
The procedure used to reset the system after an alarm condition is generated depends on
the type of alarm. Alarms are classified as either Latchable (Latching or Non-Latching) or
Non-Resettable.
The Alarm Latch DIP switch setting determines whether Latchable alarms are Latching or
Non-Latching. Use Switch 1, 5 Alarm Latch Status:
• ON = Alarm Latch Enabled Latching
• OFF = Alarm Latch Disabled Non-Latching
Error 31 x
Collapse Limit Error Latchable - Plus collapse limit exceeded
or minus collapse limit not reached.
Error 32 x
Absolute Limit Error Latchable - Plus absolute limit exceeded
or minus absolute limit not reached, or weld aborted because
of overload.
Error 33 x
Time Limit Setup Error Latchable - Value for minus limit
greater than value for plus limit, or minus limit greater than
nominal value, or plus limit less than the nominal value.
Error 34 x
Collapse Limited Setup Error Latchable - Value for minus limit
greater than value for plus limit, or plus limit less than
nominal value.
Error 35 x
Absolute Limit Setup Error Latchable - Value for minus limit
greater than value for plus limit, or plus limit less than
nominal value.
Error 37 x
TRS Lost Error Latchable - TRS was lost during weld time,
hold time, or horn down.
Error 38 x
ULS Weld Error Latchable - ULS was active during weld time
or during hold time.
Error 39 x
ULS Active Error Latchable - ULS became active while waiting
for the TRS after the ULS was already inactive.
Error 40 x
START SWITCH 1 Lost Error Non-Latching - START SWITCH 1
was lost before the trigger became active.
Table 6.11 Error Codes
Error
Code
IW IW+ Description
NOTICE
All alarms must be cleared before any weld parameters can be modified.
100-214-251 IWoper.book Page 105 Friday, June 16, 2017 4:12 PM