6
U.L. Model No.: CF621
3. Ceiling Fan Assembly
(continued)
PARTIALLY
ASSEMBLED FAN
SOLID
STYROFOAM
FACING OUT
6" - 8"
GAP
Figure 5
SPACER ATTACHMENT
SCREW
SHIPPING
SPACER
Figure 6
3.7
Turn fan motor assembly upside down in preparation
for mounting fan blades. Position the top and bottom
halves of the styrofoam packaging on end, with solid
styrofoam facing outward. Set side-by-side on the floor
with a six to eight-inch gap between the halves (Figure
5). Carefully place the partially assembled ceiling fan
on the styrofoam halves, with the hanger ball/downrod
assembly positioned in the gap and the fan motor
assembly resting on top of the styrofoam ends.
3.8
Remove the shipping spacers and the spacer
attachment screws from the motor before installation of
blade assemblies. Discard the spacers and spacer
screws (Figure 6).
CEILING
COVER
PIN
DOWNROD
HANGER BALL
SETSCREW
Figure 4
3.5
Reinstall the hanger ball (Figure 4) on the downrod as
follows. Route the motor leads through the downrod.
Position the pin through the two holes in the downrod
and align the ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan wobble.
3.6
The fan comes with blue, black and white leads that are
80-inches long. Before installing the fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and strip
back insulation 1/2-inch from end of leads.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
