9
Maintenance
Using Your Ceiling Fan
Attaching Light Kit
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
to avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
Accessories
1. Ceiling Fan Light Kits (see store or catalog).
2. Downrod Extension Kits (see store or catalog).
3. Ceiling Fan Controls (see store or catalog).
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
The use of any other control not specifically
approved for this fan could result in fire, shock and
personal injury.
WARNING
!
WARNING
!
1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box.
2. Check the operation of the fan by gently pulling on
the 4-position speed control switch pull chain. The
operating sequence is as follows:
THREE-SPEED
1st Pull—HIGH
3rd Pull—Low
2nd Pull—Medium
4th Pull—OFF
3. If airflow is desired in opposite direction, turn your
fan off and wait for the blades to stop turning, then
press the rocker switch located on top of the motor
housing, and turn the fan on again (Figure 16). The
fan blades will turn in the opposite direction and
reverse airflow.
4. Check the operation of the uplight by gently pulling
the light switch pull chain.
SPEED CONTROL
SWITCH PULL CHAIN
UPLIGHT SWITCH
PULL CHAIN
REVERSING SWITCH
TOP OF
MOTOR HOUSING
Figure 16
To install an Emerson accessory light kit, remove the
three screws securing the switch housing cover to the
switch housing. Remove the finial nut and cover pate
from the bottom of the switch housing cover and
install the light kit in accordance with the Emerson
light kit Owner’s Manual.
To avoid possible electrical shock, be sure electricity
is turned off at the main service box before wiring.
WARNING
!
