Tools Needed for Assembly
One Phillips head screwdriver
One wire stripper
Three wire connectors
(supplied)
One stepladder
Four T8 25-watt
(max.)
candelabra base bulbs
(supplied)
MATERIALS
Wiring, outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
sizes:
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is
completed, place a check mark in the box. This will insure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
1. Open styrofoam unit containing fan. Remove top
half of styrofoam unit. Remove parts and check to
see that you have received the following parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor and housing assembly
b. One motor cover
c. Once ceiling cover
d. Five blade flanges
e. One hanger bracket
f. One hanger ball/downrod assembly
g. One switch housing cover
h. One cover plate
i. One finial nut
j. One uplight lead assembly (used only for
remote control operation)
k. Four T8 25-watt candelabra base bulbs
l. One loose parts bag containing:
1. One 5/16-18 x 1/4” setscrew
2. One setscrew wrench
3. Two 1” threaded studs
4. Two 1-1/4” threaded studs
5. Four knurled knobs
6. Four lockwashers
7. Four wire connectors
8. Two pull chain pendants
3
9.
Two couplings
10. One hairpin clip
11. One clevis pin
12. Eleven 10-32 x 5/8” oval head screws
13. Sixteen 10-32 x 3/8” Phillips pan head
screws
14. Sixteen #10 flat washers
15. Three 8-32 x 3/8” pan head screws
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 7). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
WARNING
!
WARNING
!
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Installed Wire Length
Wire Size A.W.G.
Up to 50 ft.
14
50-100 ft.
12
FAN MOTOR
AND HOUSING
ASSEMBLY
BLADE
FLANGES
FINIAL
NUT
HANGER
BRACKET
SWITCH
HOUSING
COVER
HANGER BALL/
DOWNROD
ASSEMBLY
LOOSE
PARTS
BAG
COVER
PLATE
CEILING
COVER
MOTOR
COVER
