4
Model No.: ACF552
How to Put This Ceiling Fan Together
1.
Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 1). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 6.
2.
Separate, untwist and unkink the four 2 m. (80”)
motor leads/connector. Route the motor lead
wires/connector through the downrod.
3.
Remove the setscrew from the motor coupling.
Insert the downrod into the motor coupling. Align
the clevis pin holes in the downrod with the holes in
the motor coupling. Install the clevis pin and secure
with the hairpin clip (Figure 2). The clevis pin must
go through the holes in the motor coupling and the
holes in the downrod. Be sure to push the straight
leg of the hairpin clip through the hole near the end
of the clevis pin until the curved portion of the
hairpin clip snaps around the clevis pin. The hairpin
clip must be properly installed to prevent the clevis
pin from working loose. Pull on the downrod to
make sure the clevis pin is properly installed.
4.
Reinstall the setscrews in the motor coupling and
tighten securely while pulling up on the downrod.
(Figure 2).
NOTE: The setscrews must be properly installed
as described above, or fan wobble could result.
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 1
SETSCREW
CLEVIS
PIN
DOWNROD
HAIRPIN
CLIP
MOTOR COUPLING
SETSCREW
CLEVIS PIN
HAIR PIN
CLIP
CLEVIS
PIN
STRAIGHT
LEG OF
CLEVIS PIN
MOTOR COUPLING
Figure 2
DOWNROD
COUPLING
COVER
GROMMET
CEILING COVER
Figure 3
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
WARNING
!
5.
Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure that
the ceiling cover and the coupling cover are both
oriented correctly (Figure 3).
6.
Reinstall the hanger ball (Figure 4) on the downrod
as follows. Route the motor leads/connector
through the hanger ball. Position the pin through
the two holes in the downrod and align the hanger
ball so the pin is captured in the groove in the top
of the hanger ball. Pull the hanger ball up tight
against the pin and securely tighten the setscrew in
the hanger ball. A loose setscrew could create fan
wobble.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are
properly installed could result in the fan falling.
WARNING
!
HANGER
BALL
SETSCREW
PIN
DOWNROD
CEILING
COVER
Figure 4
