This document may be photocopied for personal use.
Visit our website at http://www.emersonclimate.com/ for the latest technical documentation and updates.
Join Emerson Retail Solutions Technical Support on Facebook. http://on.fb.me/WUQRnt
The contents of this publication are presented for informational purposes only and they are not to be construed as warranties or guarantees, express or implied, regarding the products or services described herein or their use or
applicability. Emerson Climate Technologies Retail Solutions, Inc. and/or its affiliates (collectively “Emerson”), reserves the right to modify the designs or specifications of such products at any time without notice. Emerson does
not assume responsibility for the selection, use or maintenance of any product. Responsibility for proper selection, use and maintenance of any product remains solely with the purchaser and end-user.
026-4842 Emerson is a trademark of Emerson Electric Co. ©2017 Emerson Climate Technologies Retail Solutions, Inc. All rights reserved.
Document Part # 026-4842 Rev 1
Page 4 of 4
The Repeater is ready to accept new links when both LEDs blink once per second again.
3. To exit Basic Setup mode and return to normal operation, press and hold both buttons for
two (2) seconds and both LEDs will blink green to confirm.
To Unlink a 3rd Party Transmitter
Follow the same steps as described to link a Module to a Repeater:
1. To access Basic Setup Mode, press and hold both buttons for two (2) seconds until both LEDs are green.
2. Press the
Set
button three (3) times to access the
Remove Link
option. When the Repeater is ready to remove links, the
Menu
LED will blink once and the
Set
LED will blink three (3) times.
3. Press the
Learn
button on the Module that is to be removed. The
Set
LED will illuminate red briefly to indicate the link was
successfully removed.
4. To exit Basic Setup Mode and return to normal operation, press and hold both buttons for
two (2) seconds and both LEDs will blink green to confirm.
To Restore Factory Defaults
Follow the steps below to restore the factory defaults to the Repeater:
1. Press and hold both buttons for 15 seconds until the
Menu
LED is solid red and the
Set
LED is solid amber.
Note: Both LEDs will turn various colors as the repeater cycles through the resetting process.
2. Press and hold the
Set
button for three (3) seconds to confirm the reset.
3. The Repeater will reboot and initiate the startup LED sequence.
4. Once the startup sequence is complete, refer to the
Configure the Repeater
section
of this document to set up the device
again.
