Ethernet Connectivity
eth0a
eth0b
eth4a
eth4b
eth4c
eth4d
eth5a
eth5b
eth5c
eth5d
Enable (circle one)
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Use DHCP (circle one)
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
Yes / No
IP address (if no DHCP)
Netmask (if no DHCP)
tablE 1:
SyStEM SEtuP WorkShEEt
An installation requires information unique to your site. Before starting the
installation, provide values for the system information listed below.
1.
A fully qualified host name for the system:
2.
The DNS domain name:
3.
Use Table 1 (below) to enter Ethernet connectivity information.
4.
A routing gateway IP address (if no DHCP):
5.
DNS server IP addresses (if no DHCP) (fill in below):
Primary
Secondary
Tertiary
6.
Select the CIFS authentication method:
Workgroup
Active Directory
Workgroup name:
Realm name:
WINS servers:
WINS servers:
Backup user
name:
Domain admin
name:
Password:
Password:
7.
Backup servers (or * for all):
8.
Administrator’s password:
9.
Host name from which to administer the system:
10.
Administrator’s email address (or admin group alias):
11.
(Optional) Description of the system’s physical location:
12.
Mail server (SMTP) host name:
13.
Time zone name (default is US/Pacific):
14.
System Controller ID from the License Code document provided in
the accessory kit. Use this ID to obtain the unique WWPN for this
controller using the WWPN tool at
https://my.datadomain.com/us/en/wwpn.jsp
15.
Record the serial number (SN) found on the back of the chassis.
Define the Data Domain System information for your Site
2
NOTE:
The system might not be usable for up to three hours if the NVRAM batteries
are discharged. Refer to the NVRAM Battery Charging Instructions for more
information.
Log into the system with the user name of
sysadmin
. The password is the
system’s serial number. At the first login, the configuration utility starts. There
are six sections to the configuration: Licenses, Network, File System, System,
CIFS, and NFS. The configuration utility guides you through the configuration
steps, one section at a time.
Complete all six sections.
uSinG thE cli conFiGuration utility
The list entries in the utility can be comma-separated, space-separated,
or both.
4
At each prompt, enter a value, OR
4
Enter a question mark (?) for more details, OR
4
Press Enter to accept the value displayed in braces.
Follow the configuration utility instructions for entering appropriate values.
At the end of each configuration section, you can choose to:
4
Save
– Save the displayed configuration.
4
Cancel
– Delete all new values and go to the next section.
4
Retry
– Restart the input entry at the beginning of the current section.
The value entered previously appears as the default value at each prompt.
Perform initial System configuration
3
