EMBRON Hatteland Technology Series 1, Руководство пользователя

Страница: 30 / 62

30 User Controls
IND100064-34
OSD Menu Functions
OSD Menu Functions
The following section covers all possible settings that the user can (in a certain mode) encounter or needs to adjust.
The structure of these commands are identified as paths. Please review the “OSD Menu Overview Map” earlier in this
manual to see the different paths if you have not already made yourselves familiar with the OSD Menu structure. Most
functions are performed in real time so you do not have to exit the OSD menu to see the results.
Please note: Available functions described may deviate slightly from actual OSD menu on your product.
This is due to different OSD software configurations and customized solutions.
Display / Picture / Brightness
Function only available in “Full” menu mode.
Increase/decrease the overall brightness of the panel electronically by controlling the voltage level.
This applies to the Main Source signal. Window overlays (PIP/PBP) and the OSD Menu overlay will be
unaffacted. This will be independent of the actual adjustment done by the front user controls like potmeters
or buttons.
● Level adjusts from 0-100 steps. 50 is default.
Display / Picture / Contrast
Function only available in “Full” menu mode.
Increase/decrease the overall contrast of the panel electronically by controlling the voltage level.
This applies to the Main Source signal. Window overlays (PIP/PBP) and the OSD Menu overlay will be
unaffacted. This will be independent of the actual adjustment done by the front user controls like potmeters
or buttons.
● Level adjusts from 0-100 steps. 50 is default.
Display / Picture / Phase
This function only apply for analog VGA/RGB signals.
Fine tune the data sampling position of the signal (impacts on image quality). This function will remove
small transparent defects in typical characters where a portion seems to be more faint then the nearby
black pixels. The faint pixels are always visible as a line from top to bottom (vertically).
● Level adjusts from 0-100 steps. Default is based on signal source.
Display / Picture / Frequency
This function only apply for analog VGA/RGB signals.
Adjust the horizontal frequency of the analog signal to improve visibility of the entire image. When it is ad-
justed, you will notice that the image will appear to be stretched and might in some situations start to flicker/
scroll, at which point you must reverse the last adjustment to stop it from flickering/scrolling anymore. This
function can be used for older signals that is not automatically detected by the internal display
controller.
● Level adjusts from 0-200 steps. Default is based on signal source.