EMBRON Hatteland HD 12T21 MMC Series, Руководство пользователя

Страница: 27 / 124

27
Installation Procedures
Installation
IND100078-51
Panel / Console Mounting Bracket Kit for 12”, 15”, 17” and 19”
You need: Allen Wrench tool (3mm), 4 pcs of HD CMB SX1-A2 or -A3 Kit (-A2 included in delivery).
Procedure suitable for: Display and Panel Computers. Brackets are EN60945 Tested.
Attention: A suitable pre-cut panel cutout should be made prior to mounting. Do not force the
unit into the panel cutout as it might break the outer glass or scratch the chassis on the unit. Make
sure that the panel cutout is not too tight for the unit. Please disconnect ALL cables before
proceeding. Please re-check the relevant and required panel cutout measurements if unsure.
Confirm you have the
Double Key Hole
model before
proceeding!
1: Slide the unit into the cutout carefully.
User Controls and Connector Area should
be facing downwards.
2: Prepare and position the brackets into each
of the four key holes. The key part goes into
the unit’s largest area of the keyhole, while the
Allen screw is visible at the top. See closeup.
3: When all brackets fits inside the keyhole, slide them to opposite positions from eachother (upper to up, and lower
to down) into the narrow gaps, If you are unable to slide them up/down, simply adjust/loosen the top Allen Screw
slightly and try again.
4: Secure the unit by fastening the top Allen screws fairly. Make sure you do it equally and even for all 4 sides. Do
not use excessive force. See closeup of a open and closed position to the right.
Open Closed