DATAPLOT GmbH
Gutenbergstraße 15
24558 Henstedt-Ulzburg
Germany
Telephone: +49 4193 995-0 Fax: +49 4193 995-220
www.dataplot.de
Page 26 / 28
5.
Tighten the two Allen screws, slide the upper die
upwards and downwards and control again for the
correct position.
5.2
Die for plastic eyelets
1.
Remove the compressed air hose.
For the remainder of the installation procedure there
must be no pressure on the device!
2.
Actuate the manual operating lever to drive the finger
guard downwards.
Then pull the upper die downwards with the other hand.
3.
Check the position of the upper die relative to the lower
die. The dies must be exactly centred over each other
and the upper die must fit into the lower die without
snagging.