INSTALLATION
Continued
5. Retighten and adjust the location of the
gas control as necessary. The gas control
should be level, with the control knob to the
front.
Figure 6 - Installing Inlet Fitting and Gas
Connector Tube (Heat Shield Removed
for Clarity)
Gas Control Valve
Propane/LP Gas Conversion
To convert to Propane/LP gas, the regulator pres-
sure must be reset. Also, burner inle
t fitting
and
pilot
orifice
must be replaced. The Propane/LP
burner inlet
fi
tting is supplied wit
h the orifice installed
Burner Inlet Fitting
1. Remove pilot assembly burner pan by remov-
ing two screws on bracket.
2. Unthread control valve and burner
inlet fitting
from burner tube by turning valve counterclock
wise (see
Figure 7
) .
Remove Natural Gas inlet
fi
tting from control
valve assembly(see
Figure 8
).
DO NOT remove ori
fi
ce from this
fi
tting. The
Propane/LP burner inlet
fi
tting is provided in
the hardware kit (see
Figure 8
).
3.
Be sure to use the correct
orifice
for your app-
liance. The ori
fi
ce kit included with this appli-
ance contains an
orifice
installed in an air
mixer fitting.
4. Using thread sealant (resistant to the action
of propane/LP gas) on smaller end of
fi
tting,
screw the burner inlet
fi
tting into outlet side of
gas control. Tighten using a wrench.
5 . Rethread valve and
fitting
assembly into
burner tube until fully threaded and level with
burner pan. Reattach valve cover with two
(2) screws.
NATURAL GAS
COMPONENTS
Burner Inlet Fitting
for Natural Gas
Figure 7 - Burner Inlet Fitting and Pilot Prifice
Natural Gas
Pilot Orifice
Figure 8 - Burner Inlet Fittings shown with orifice
NATURAL
GAS
FITTING
PROPANE/LP
GAS FITTING
Orifice for
Natural Gas
Injector for
Propane/LP Gas
7
NG to LP Regulator Selection
The appliance regulator can be converted from Natural
Gas to LP/gas. If connecting to a Propane gas system,
regulator must be switched prior to use. Follow the
the
steps below to select Propane/LP gas.
1. Carefully remove the logs from the burner assembly.
2. Make sure gas is turned off to the unit and disconnect
burnerassemblyfromgasline.Removeburnerassemb-
ly from fireplace or firebox.
3. Locate the regulator cap on the appliance regulator (see
Figure 9
Unscrew by hand and remove
the cap from the regulator.(The pressure selecting
screw is attached to the regulator cap.) The pressure
selecting screw is supplied in the Natural Gas position.
4. Unscrew and remove the pressure selecting screw
from the regulator cap (see
Figure 9
).
WARNING: Only a
qualified
installer or
service technician can perform gas con-
version and connection to gas supply.
SELECTING GAS TYPE
This appliance can be used with Propane/LP gas or
Natural Gas. It is shipped from the factory adjusted
for use with Natural Gas. Main burners are equipped
with fixed orifices, located at the inlet of the burner
pan (see
Figure 7
).
for your log set.
Retain the removed Natural Gas components
for future use.
Pilot Orifice Replacement
Disconnect the pilot supply tube from the pilot (See
Figure 7
). Replace the pilot orifice with the Propane/LP
pilot orifice included with the Gas conversion kit. Retain
the removed orifice for future use.
on Page 8)