EMB Wallenstein GX600, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 16

6
Starting Operation
Back up tractor close to backhoe, then plug the two hoses from the
backhoe into the tractor auxillery outlets. With the stabilizers, lift the
backhoe to the right height (12” ground clearance. Raise tractor lift
arms to correct height. Insert pins. Never attempt to raise three point
hitch while backhoe is on tractor— damage to tractor or backhoe could
occur.
Disconnecting Procedure
When disconnecting the backhoe from the tractor, lower stabilizers and
lift backhoe until pins slide out easily. Remove pins and move tractor
ahead a few inches, lowering the backhoe to the ground by lifting the
stabilizers. Disconnect all hydraulic lines from the tractor. Always store
your backhoe on a flat and solid surface in a dry location. Be sure to
have the bucket attached to the backhoe prior to storage to avoid a sta-
bility problem when re-attaching the backhoe.
Maintenance
Grease all lubrication points with a grease gun daily. See tractor man-
ual for hydraulic oil/filter change recommendations. Check daily for oil
leaks, tighten if necessary. Check daily for loose or missing pins and
bolts, replace or tighten if necessary.
Initial Setup
When using a tractor with the backhoe for the first time, the 3 point hitch
rigid link may need to be adjusted so the backhoe operators platform
sits level. Set up 3 point hitch mounting kit as shown in the photograph
below. The backhoe should have approximately 12” of ground clear-
ance (less on GX-600 on smaller tractors).