Tinyhawk
3
emax-usa.com
Radio
Battery and Charging
This is a 6 channel 2.4 GHz radio, The radio is powered with an 18650 battery. The
radio comes with the battery installed; however if a reinstall is needed make sure the
negative side is on the side touching the spring of the radio. The radio can be
charged with a micro usb cable attached right below the speaker and power button.
Operation
Power
Power on and off by holding the power button for 2 seconds. The center light will turn
green when on.
Binding
The radio comes already bound to tinyhawk in the ready to fly kit. If binding is
necessary follow these steps:
1. Put tinyhawk into binding mode by pressing and holding the bind button while
powering on tinyhawk. A green light will power on tinyhawk flight controller
indicating in bind mode.
2. Put the radio into bind mode by first powering on the radio and then press
and hold both the throttle trim down and pitch trim down buttons for 2
seconds until a red light turns on next to the green light around the power
button. Release the buttons and the red and green lights will flash indicating
the radio is in binding mode.
