Tinyhawk
8
emax-usa.com
Fly Tinyhawk
Start by powering on your Radio and Goggles. Tinyhawk comes already bound to
your radio and on the right video channel matched with your goggles. Power on
tinyhawk by sliding the battery into the battery tray and plugging it in. Once the
battery is plugged in, set tinyhawk on a stable surface so it can calibrate. Calibration
takes a few seconds then tinyhawk is ready to fly. Tinyhawk can fly for 4 minutes on
a fully charged battery. Land tinyhawk when the battery reaches 3.2v; flying any
longer can severely damage your battery and is not recommended.
Arming
Arming refers to setting tinyhawk to a fly ready state. When tinyhawk is powered on
first it will not spin up the propellers until it is armed. Arm the aircraft by first moving
throttle to the bottom position. Then move the left switch of the radio to its 3
rd
position
upwards. You will see the propellers spinning when tinyhawk is successfully armed.
In the event of a crash always disarm immediately. Failure to disarm in a timely
manner can damage tinyhawk.
Always disarm tinyhawk before handling it. Disarm tinyhawk by setting the arm
switch to its 1
st
position (bottom).
Flying Modes
The right switch on the radio controls the different flight modes of tinyhawk. There
are 3 modes: easy, intermediate, and advance. The switch in its first position
downward is easy mode, second position is intermediate, and third position is
advanced.
2. Switch to Arm Position
3. Connect Battery
2. Install Battery
1. Turn on Transmitter
