53
GB
Water supply
We recommend that you use an authorised installer to
connect to the water supply.
Connect the supply hose as shown in the diagram.
1. Connect the elbow to the water tap and turn clock-
wise to tighten.
2. Connect the other end of the supply hose to the inlet
valve at the rear of the washing machine and tighten
it securely (clockwise).
Note! If there is any leakage from the hose after connection, repeat all the steps for con-
necting the supply hose. Use a conventionally designed tap to supply the water. If the tap
has a square spout or is too large in diameter you should replace it with a standard tap.
Drain hose
There are two ways to connect the drain hose:
Alternative 1: Connect it to a waste pipe. This method is suitable if there is a suitable
coupling accessible.
The drain hose should run no higher
than 100 cm above the floor.
Alternative 2: Connect to a sink or open drain.
• Secure the drain hose once it has been installed.
• Position the drain hose so that water cannot leak
on to the floor.
Installation
M
ax.100c
m
Min.60c
m
Max.100cm
Min.60cm
Min.60
cm
M
ax.100c
m
Water througs
Suspension bracket
drainhose
Set