-
A
B
67
© 2021, Elon Group AB. All rights reserved.
Integrated installation (for the integrated
model)
Step 1. Selecting the best location for the dishwasher
The installation position for the dishwasher should be near the
existing inlet and drain hoses and power cord.
The illustrations below show the cabinet dimensions and the
recommended installation position for the dishwasher.
1. The gap between the top of dishwasher and cabinet, and
between the edge of the outer door and the edge of the
cabinet should be less than 5 mm.
2. If the dishwasher is installed in a corner cabinet there
should be some space when the door is opened.
NOTE
:
Depending on where your electrical outlet is, you may need
to cut a hole in the side of the nearest cabinet.
Step 2. Adjusting the door spring tension
1. The door springs are set at the factory to the correct
tension for the outer door. If a wooden door panel is fitted,
you will have to adjust the door spring tension. Rotate the
adjusting screw to tighten or relax the steel cable.
2. The door spring tension is correct when the door remains
horizontal in the fully opened position, but rises to the
closed position with slight finger pressure.
Space between
cabinet bottom
and floor
Electrical, drain and
water supply line
openings
90°
Step 3. Dishwasher installation steps
1. Fit the condensation strip under the work surface of the
cabinet. Please ensure the condensation strip is flush with
the edge of the work surface.
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher in position.
6. Level the dishwasher. The rear foot can be adjusted from
the front of the dishwasher by adjusting the screw in
the middle of the base of the dishwasher using a cross-
head screwdriver. To adjust the front feet, use a flat-head
screwdriver and turn the front feet until the dishwasher is
level.
7. Adjust the tension of the door springs by using an Allen
key, turning in a clockwise direction to tighten the left and
right door springs. Failure to do this could cause damage
to your dishwasher.
8. The dishwasher must be secured in place. There are two
ways to do this:
A.
Normal work surface: Secure the dishwasher to the
work surface with the wood screws and retaining strip.
B.
Marble or granite work top: Fix the sides with screws.
Step 4. Levelling the dishwasher
The dishwasher must be level to ensure correct dish rack
operation and wash performance.
9. Place a spirit level on the door and the rack guide inside
the dishwasher as shown to check that the appliance is
level.
10. Level the dishwasher by adjusting the three levelling feet
individually.
11. Once the dishwasher is level, make sure that it cannot tip
over.
90°
820 mm
580 mm
80
100
600 mm (for 60 cm model)
450 mm (for 45 cm model)
Dishwasher
Door of
dishwasher
Minimum space
of 50 mm
Cabinet
Содержание CDM2451V
Страница 135: ...135 2021 Elon Group AB All rights reserved...