OmniFocus 200 Series Installation and Operation Guide
First Light
1. Turn on projector.
2. Remove the large lens cap by pulling it off.
Do not attempt to unscrew the lens cap.
●
Take care not to scratch the fisheye element/lens while removing and replacing cap.
3. You should see the projector startup screen.
4. Adjust focus using either the projector control panel or remote control. (Fig. 3 above)
●
Focus to “good enough”. Final focus is done after setup is complete.
●
For
fine
Focus and Zoom adjustments use the left and right arrow keys.
Projector Settings Adjustment
With the 200 Series, the stock lens not only has Focus and Zoom adjustment but also Lens
Shift. This added capability allows optimization of the projected image. The system is
already delivered in a nearly optimal state so any adjustments to be made will be minor.
1. Use the projector remote control or control panel to make any needed adjustments. The
following images show the projector nominal Display and Focus settings for truncated
(180°x112°) projection mode as well as the nominal Zoom and Lens Shift settings.
Elumenati, GeoDome OmniFocus and OmniMap are all trademarks of The Elumenati LLC.
(Fig. 6) Nominal Display and Focus settings for truncated projection.
