www.prolight.co.uk
DB1300 DMX Stage Blinder
User Manual
4
CONNECTION WITH THE MAINS
Connect the fixture to the mains with the power plug. The occupation of the connection cables is as follows:
Attention!
The earth has to be connected.
If the device will be directly connected with the local power supply network, a disconnection switch with a minimum opening
of 3mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC standards. The electric
installation must be equipped with a Residual Current Device (RCD) with a maximum fault current of 30mA.
CONNECTION WITH THE MAINS
If the lamp burns out, the fine-wire fuse of the fixture might fuse too. Only replace the fuse by a fuse of the same
type and rating.
Before replacing the fuse, unplug the mains lead.
To replace the fuse follow the procedure below:
Step 1:
Unscrew the fuse holder on the rear panel with an appropriate screwdriver from the housing anti-clockwise.
Step 2:
Remove the old fuse from the fuse holder.
Step 3:
Install the new fuse in the fuse holder.
Step 4:
Replace the fuse holder in the housing and screw it back in.
OPERATING DETERMINATIONS
If this equipment is operated in any other way, than those described in this manual, the product may suffer damage and
the warranty becomes void. Incorrect operation may lead to danger e.g: short-circuit, burns and electric shocks etc.
Do not endanger your own safety and the safety of others!
Incorrect installation or use can cause serious damage to people and/or property.
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
Safety advice & installation
DANGER TO LIFE!
WHEN INSTALLING THE FIXTURE, MAKE SURE THERE IS NO
HIGHLY-INFLAMMABLE MATERIAL WITHIN A MINIMUM DISTANCE OF 0.5m.
