ELTRA CHS-580A, Руководство по эксплуатации и обслуживанию

Страница: 30 / 35

Error messages
30
Pos : 1. 31 /0025 Übersc hrift en/ELTRA 1. Ü bersc hrift en/ 1 Err or mes sages @ 11\ mod_1435644207306_9. doc x @ 84324 @ 1 @ 1
11 Error messages
Pos : 1. 32 /0010 ELTR A/ 0010 operati ng_i nstructions /Aut oloader _CS580A_CH S580a_H elios/ 55 M odul Error messag es @ 11 \mod_1435047174702_9. doc x @ 83542 @ @ 1
The loader electronic board contains a buzzer for signalizing errors. The number of beeps in a
row specifies the problem according to the table below.
=== Ende der List e f ür T ext mar ke I nhalt ===
No. of
beeps
Error description
1
The beam of the vertical laser cannot be detected.
Defective laser or detector, dirt in between, arm in between.
2
The beam of the vertical laser is continuously detected.
Error of the fing
er’s motor.
3 No crucible on the loader although the loader received the command to load the next crucible.
4
The beam of the horizontal laser cannot be detected.
Defective laser or detector, crucibles don’t move due to blockage, defective motor, etc.
5
The furnace is not opened for the loader to place a crucible on to the pedestal.
Error in the piston control or piston sensor.
6
The fingers didn’t take the crucible. The crucible blocks in its tray, no compressed air, faulty laser or
sensor, etc.
7
The loader received the command for loading but the furnace is not open, or the piston came down with
big delay.
8 One dispenser empty.
9 One dispenser empty.
∞
Infinitive number of beeps in manual mode.
Piston sensor disadjusted (low end of furnace cylinder).