ELTEX WOP-2L, Руководство пользователя

Страница: 26 / 65

WOP-2L. User manual
26
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Routes:
Interface – name of the bridge interface;
Destination – IP address of destination host or subnet that the route is established to;
Gateway – gateway IP address that allows for the access to the Destination;
Netmask – subnet mask;
Flags – certain route characteristics. The following flag values exist:
U – means that the route is created and passable;
H – identifies the route to the specific host;
G – means that the route lies through the external gateway; System network interface provides routes
in the network with direct connection. All other routes lie through the external gateways. G flag is used
for all routes except for the routes in the direct connection networks;
R – indicates that the route was most likely created by a dynamic routing protocol running on the
local system using the reinstate parameter;
D – indicates that the route was added as a result of receiving an ICMP Redirect Message. When the
system learns the route from the ICMP Redirect message, the route will be added into the routing
table in order to exclude redirection of the following packets intended for the same destination;
M – means that the route was modified – likely by a dynamic routing protocol running on a local
system with the 'mod' parameter applied;
A – points to a buffered route to which an entry in the ARP table corresponds;
C – means that the route source is the core routing buffer;
L – indicates that the destination of the route is one of the addresses of this computer. Such 'local
routes' exist in the routing buffer only;
B – means that the route destination is a broadcasting address. Such 'broadcast routes' exist in the
routing buffer only;
I – indicates that the route is connected to a ring (loopback) interface for a purpose other than to
access the ring network. Such 'internal routes' exist in the routing buffer only;
! – means that datagrams sent to this address will be rejected by the system.
5.4.6 The 'Device Information' submenu
The 'Device Information' submenu displays main WOP-2L parameters.
Product – device model name;