WOP-2L. User manual
55
6.4 Radio configuration
In the Radio section, automatic selection of the working channel is used by default. To set the channel manually
and change the power, use the following commands:
Change of opeartion channel and radio interface power
WOP-2L(root):/#
configure
WOP-2L(config):/#
interface
WOP-2L(config):/interface#
wlan0
WOP-2L(config):/interface/wlan0#
wlan
WOP-2L(config):/interface/wlan0/wlan#
radio-2g
WOP-2L(config):/interface/wlan0/wlan/radio-2g#
tx-power X
(where X – power level, dBm. Parameter can
take the following value: for Radio 1: 11-16 dBm; for Radio 2: 11-19 dBm)
WOP-2L(config):/interface/wlan0/wlan/radio-2g#
auto-channel false
(Disable Auto Channel. To enable, enter
true
)
WOP-2L(config):/interface/wlan0/wlan/radio-2g#
use-limit-channels false
(Disable Use Limit Channels. To
enable, enter
true
)
WOP-2L(config):/interface/wlan0/wlan/radio-2g#
channel X
(where X – number of the static channel on
which the point will operate)
6.4.1 Advanced Radio settings:
Changing the channel bandwidth
WOP-2L(config):/interface/wlan0/wlan/radio-2g#
bandwidth X
(where X – bandwidth. Parameter can take
the following value: for Radio 1: 20, 40; Radio 2: 20, 40, 80.)
Changing the primary channel
WOP-2L(config):/interface/wlan0/wlan/radio-2g#
control-sideband lower
(Parameter may take values:
lower, upper. By default: for Radio 1: lower; for Radio 2: upper)
Switching on the use of Short Guard Interval
WOP-2L(config):/interface/wlan0/wlan/radio-2g#
sgi true
(Switching on the use of a Short Guard Interval for
data transmission of 400 ns instead of 800 ns. To disable, enter
false
)
