ELTEX MES3108, Руководство по эксплуатации, Страница: 164 / 243

164 MES3000 Ethernet switch series
show fiber-ports
optical­transceiver theshold
[interface {gigabitethernet
gi_port | tengigabitethernet
te_port }]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4).
Show the current settings of the automatic monitoring for the
selected port or all system ports.
Example execution of the command
sw1# show fiber-ports optical-transceiver interface gi1/0/24 detailed
Port Temp Voltage Current Output Input LOS Transceiver
[C] [V] [mA] Power Power Type
[mW / dBm] [mW / dBm]
----------- ------ ------- ------- ------------- ------------- --- -------------
gi1/0/24 58 3.25 20.09 0.58 / -2.30 0.00 / -40.00 Yes Fiber
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts
Input Power - Measured RX received power in milliWatts
LOS - Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Transceiver information:
Vendor name: OEM
Serial number: SX31221300026
Connector type: LC
Type: SFP/SFP+
Compliance code: 10GBASE-LR
Laser wavelength: 1310 nm
Transfer distance: 10000
Diagnostic: supported
Table 5.190 —Optical transceiver diagnostics parameters
Parameter Value
Temp Transceiver temperature.
Voltage Transceiver power voltage.
Current Current deviation for transmission.
Output Power Output power for transmission (mW).
Input Power Input power for receiving (mW).
LOS Loss of signal.
During the detailed diagnostics, measured values for Temp, Voltage, Current, Power parameters are
shown on display. During the regular diagnostics, measured values for these parameters are compared to
the allowable values, and the comparison results are shown on display (W, E, OK).
Diagnostics and parameter comparison results:

N/A—not available

N/S—not supported

W—warning

E—error

ОК—value is OK