P R O G R A M M I N G
_________________________________________________________________________________
GsmAlarm-500
Software ver. 1.15
-
15-
Important:
a)
No characters/spaces can be used before the password;
b)
No spaces are allowed before and after the colon;
c)
Spaces must follow the password and each phone number;
d)
It is recommended to enter user numbers with international code (e.g. +123…).
It is not necessarily to send all user numbers. e.g., in order to programme only the first user number,
send the following SMS:
A A A A A A A A A L R N R 1 : + 3 7 0 6 1 2 3 4 5 6 7 8 9
Receipt and decrypting of the SMS by GsmAlarm-500 is confirmed by blink of indicator MODE.
The phone, which has sent the programming SMS, immediately receives a confirming SMS with
programmed numbers.
In order to delete unnecessary number, send the following SMS:
A A A A A A A A A L R N R 2 : N
Number ALRNR2 is deleted; user receives SMS with programmed numbers. In order to replace one
number with another, no separate instruction for deletion needs to be sent.
In order to receive SMS with programmed numbers ALRNR1 ... ALRNR5, send GsmAlarm-500
the following SMS:
A A A A A A A A N R I N F O
Extra user numbers (only for gate control) are programmed by sending the following SMS:
A A A A A A A A A D D N R : + 3 7 0 1 2 3 4 5 6 7 8 9 1 A D D N R : + 3 7
0 7 0 1 2 3 4 5 6 7 8 9 2 A D D N R : + 3 7 0 1 2 3 4 5 6 7 8 9 3
ADDNR: – new number programming instruction.
+3701234567891 – new user number.
If the numbers programmed successfully, the user, who sent the message, receives SMS with newly
programmed number. In this case the confirmation message will be:
USER1:+3701234567891 USER2:+3701234567892 USER3:+3701234567893
USER1 – name, assigned to the new number.
If a short call controls several outputs, an additional number may be assigned only to a single output.
In this case, the programming message is the following:
A A A A A A A A A D D N R - C 1 : + 3 7 0 1 2 3 4 5 6 7 8 9 1 A D D N R -
C 2 : + 3 7 0 1 2 3 4 5 6 7 8 9 2 A D D N R - C 3 : + 3 7 0 1 2 3 4 5 6 7 8
9 3 A D D N R - C 4 : + 3 7 0 1 2 3 4 5 6 7 8 9 4
The first number controls only the output C1, the second, C2, the third, C3, the fourth, C4 (K1, K2).
To control any output by one-touch command, write: ADDNR-C0:+370123456789.
Up to 8 user numbers might be programmed with one SMS message.