14
CYBOX GW 2-P
e
s
IN
ST
AL
LA
TI
O
N
M
AN
U
AL
4.1
CONNECTING AN EARTHING CABLE
A M6 earthing stud on the front panel of the device (also refer to Figure 1) for protective earth connection
is essential for the device security. Carry out the following steps to connect an earthing cable:
•
Use an earthing cable with a cross-section of at least 2.5 mm² and a wire end sleeve with eyelet
suitable for a 6 mm threaded bolt.
•
Mount the earth cable as shown in Figure 6.
•
Fasten the cable by tightening the nut to the required torque
(recommended according to EN 60947-1 are 3 Nm).
Figure 6
Earth Cable Mounting on Earth Stud
4.2
ELECTRICAL CONNECTION
1.
Make sure the device is properly grounded.
2.
Establish a connection to the network by plugging a M12 patch cable to one of the front panel M12
connectors. Each LAN port may be used if the gateway is supplied by a local power supply through
the power supply connector.
3.
Connect the desired number of antennas to the device. Each radio/modem can use up to four
antennas for maximal performance.
4.
In case of using a local power supply the appropriate wiring (see Table 1 ) must be established to
connect the power line to the device.
5.
Make sure that the voltage of the power supply conforms to the voltage on the type plate.
6.
Ensure that the power supply is grounded correctly and that the power cable is intact and
undamaged. Do not switch on the system if there are damages on the power cable or plug.
7.
Use power cables which are approved for the power supply in your country.
8.
The device itself has no on/off switch, it starts as soon as it is supplied with power.
