Eltax Voyager BT10, Инструкция по эксплуатации

Страница: 4 / 8

UK
• Correctly install the battery.
• Turn the power switch to «ON». If the indicator LED does not flash or always lights, please check the battery. Battery voltage
may be insufficient, or the polarity is installed oppositely.
• Before using wireless microphone, please extend the rod antenna and make it vertically upward to ensure better reception.
• Adjust the microphone volume on the Voyager BT according to the sound volume when singing.
• Keep away the receiving antenna from metal surface, wall or other obstacles, as it can significantely reduce the signal.
• The effective using distance of wireless microphone is within 30 meters. When the battery is low, or if there are too many
interferences, the using distance will be shortened accordingly.
• To enjoy the best singing effect, the distance between mouth and microphone shall be 5-15cm, and the best angle is 45
degrees.
• When the battery is low, the indicator LED will light. Please change the battery in time in order not to affect the singing effect.
• Please keep away the microphone from the speaker to avoid Larsen effect.
• If you have purchased more than two sets of Voyager BT with wireless microphones and intend to use them together, please
select the varieties in different standard frequencies. If the frequency is identical, two Voyager BT can not be used until they
are separated from each other for 100 meters, so as to avoid mutual interference and other troubles.
NB : frequencies are indicated in the battery slot.
Wireless microphone
Troubleshooting
10" woofer
Piezo tweeter
Power : 250W
Sensitivity : 95dB/W/m
Frequency response : 50-20 kHz
Battery : 7.4V/2000mAh Li battery
Battery life : 10 hours*
Dimensions (WxHxD) : 265 x 445 x 280 mm
Weight : 4,3 kg
All specifications are subject to change without notice.
* Battery life will vary with use.
FAULT PHENOMENON ANALYSIS SOLUTION
Failing to power on
• The power switch is not opened.
• The built-in battery is totally discharged.
• Open power switch.
• Use power adaptor to charge the battery.
No sound
• Failing to input sound source.
• Main volume is switched to minimum.
• USB disk playing has no sound.
• Poor contact or damage of external signal line.
• Change signal source.
• Properly adjust the volume knob.
• Inspect USB disk or audio switch.
• Readjust or change signal line.
External microphone has no sound
• External microphone is not fully inserted in the jack.
• The external microphone switch is not opened.
• The volume knob of microphone is off.
• Totally insert the microphone to the jack.
• Open the switch of wireless microphone.
• Properly adjust the volume knob of microphone.
Problems with wireless microphone
• The switch of wireless microphone is not opened.
• The battery is not inserted in the microphone.
• The sound of the wireless microphone is in distorsion.
• Open the switch of wireless microphone.
• Insert battery in the wireless microphone.
• Change the battery of wireless microphone.
Specifications
Panneau de
commandes
(1)
Bouton Marche/arrêt
des LED en façade
Interrupteur On/Off