ELTA FANS MORI dMEV II HT, Руководство по установке

Страница: 3 / 16

3
VERSIONS
MORI dMEV II T (Timer version)
The fan is provided with over-run timer, adjustable from 0-30 minutes via a trimmer (fig.
17A). The fan works at the selected trickle speed (or off) and can be boosted using the
integrated pull cord switch or light switch. Once the boost switch is turned off the fan
will continue to run at the boost speed for the set period of time before reverting back
to the trickle speed.
The over-run timer function is activated only if the switch has been on for at least 60
seconds.
Pull Cord Operation:
The pull cord works as the boost switch. Wire up as per diagram
(fig. 16A).
External Switch Operation:
To boost the unit with an external switch such as a light
switch the pull cord should be disabled. To do this make sure the pull cord switch is
not on and simply cut the cord. The plastic caps on the wiring terminals will need to be
removed to allow the switch wires to be secured. Wire up as per diagram (fig. 16B).
External Switch and Pull Cord Operation:
If the fan needs to be boosted via a pull cord
and external switch the switch used must be a double pole switch. This removes any
interference between the fan and the light. Wire up as per diagram (fig. 16B).
MORI dMEV II HT (Humidity control version)
The fan comes complete with an adjustable humidity sensor and adjustable timer. The
humidity threshold is adjustable from 50% to 95% Relative Humidity via a dedicated
trimmer, and the timer is adjustable from 0 - 30 minutes via a dedicated trimmer (fig. 17B).
The fan works at the selected trickle speed (or off) and can be boosted using the
integrated pull cord switch or light switch. Once the boost switch is turned off the fan will
continue to run at the boost speed for the set period of time before reverting back to the
trickle speed. There is also a comfort boost triggered by a humidity level above the set
threshold. The Comfort Boost flow rate is approximately half way between the pre-set
Background and Boost flow rate. Once the humidity level is below the set point the fan
will continue for a factory set period of time before returning to trickle speed.
To deactivate the humidistat function, turn the trimmer HY completely clockwise.
Pull Cord Operation: The pull cord works as the boost switch. Wire up as per diagram
(fig. 16D).
External Switch Operation: To boost the unit with an external switch such as a light
switch the pull cord should be disabled. To do this make sure the pull cord switch is
not on and simply cut the cord. The plastic caps on the wiring terminals will need to be
removed to allow the switch wires to be secured. Wire up as per diagram (fig. 16E).
External Switch and Pull Cord Operation: If the fan needs to be boosted via a pull cord
and external switch the switch used must be a double pole switch. This removes any
interference between the fan and the light. Wire up as per diagram (fig. 16E).
Installation type can be selected using the JUMPERS among different options. See fig. 18.
Trickle speed can be selected using the JUMPERS among different options. See fig. 18.
Trickle speed can be also set to off.
INSTALLATION TYPE SETTING
TRICKLE SPEED SETTING