9
Installation and commissioning
Weather Station Suntracer KNX-GPS light
• Version: 15.07.2013 • Technical changes reserved. Errors reserved.
2.1.6. PCB layout
2.1.7. Mounting the weather station
Close the housing by putting the cover back over the bottom part. The cover must snap
in on the left and right with a definite “click”.
Fig. 11
1
Tension clamp for auxiliary voltage supply. For massive conductors of up to
1.5 mm² or conductors with fine wires. Terminal configuration independent from
polarity (+/- or -/+).
2
KNX clamp +/-
3
Slot for cable connection to the rain sensor in the housing cover
4
Programming pushbutton for the teach-in of the device
5
Programming LED
6
Control LED GPS reception. As soon as valid GPS data is received, the LED blinks
1x per second. After the auxiliary supply voltage has been connected, it may take
some minutes before reception is established.
1
2
6
4
5
3
