8
Installation and commissioning
Weather Station Suntracer KNX-GPS light
• Version: 15.07.2013 • Technical changes reserved. Errors reserved.
2.1.5. Preparing the weather station
The weather station cover with the rain sensor snaps in on the left and right along the
bottom edge (see Fig.). Remove the weather station cover. Proceed carefully, so as not
to pull off the wire connecting the PCB in the bottom part with the rain sensor in the
cover.
Push the power supply and bus connection cable through the rubber seal on the bot-
tom of the weather station and connect voltage and bus +/- to the provided clamps.
Fig. 9
1
Lid with rain sensor
2
Lid notches
3
Housing lower section
2
3
Unsnap cover and
remove upwards
1
Fig. 10
Remove the cable shielding under the circuit
board and only feed the connector cables up-
wards through the openings in the circuit
board.
