7
Installation and commissioning
Weather Station Suntracer KNX basic
• Status: 15.07.2013 • Technical changes reserved. Errors reserved.
2.2.3. Preparing the weather station
The weather station cover with the rain sensor snaps in on the left and right along the
bottom edge (see Fig.). Remove the weather station cover. Proceed carefully, so as not
to pull off the wire connecting the PCB in the bottom part with the rain sensor in the
cover (soldered cable connection in case of 230 V AC version, cable with plug in case
of 24 V DC version).
Push the power supply and bus connection cable through the rubber seal on the bot-
tom of the weather station and connect voltage LN and bus +/- to the provided clamps.
Fig. 9
1
Screw-on cover (230V
device)
2
Cover with rain sensor
3
Cover snaps
4
Bottom part of housing
3
4
Unsnap cover
and remove upwards
2
1
