Elsner 70156, Установка и настройка

Страница: 28 / 52

26 Parameter setting
Weather Station Suntracer KNX sl basic • Version: 26.08.2021 • Technical changes and errors excepted.
"General settings" parameter block. The "Software version" communications object is
sent once after 5 seconds.
6.0.2. Storage of threshold values
For threshold values that are specified via a communication object, a starting value
must be entered for the first commissioning. It is valid until the first communication of
a new threshold value.
After this, a threshold value once set per parameter or via a communication object is
retained until a new threshold value is sent via a communication object. The last thres-
hold value set by communication object is saved in the device, so that it is retained du-
ring a power outage and is available once again when power is restored.
6.0.3. Malfunction objects
Malfunction objects are sent after every reset and, additionally, after changes (i.e. at
the beginning and end of a malfunction).
6.1. General settings
Set basic characteristics of data transfer. A different transmission delay prevents an
overload of the bus shortly after the reset.
6.2. Rain
Activate the rain sensor in order to use objects and switch outputs.
Set, in which cases delay times received are to be kept per object. The parameter is
only taken into consideration if the setting by object is activated further down. Please
note that the setting "After power restoration and programming" should not be used
for the initial start-up, as the factory settings are always used until the first call (setting
via objects is ignored).
Transmission delay after reset/restoration of bus for:
Measured values 5 … 300 seconds
Threshold values and switching outputs 5 … 300 seconds
Computer objects 5 … 300 seconds
Logic objects 5 … 300 seconds
Maximum telegram quota 1 • 2 • 5 • 10 • 20 • 50 Telegrams per sec.
Use rain sensor No • Yes
Maintain the
delays received via communication objects • never
• after power restoration
• after power restoration and
programming